Flat Sheet Roll Forming Machine

Main parameter
De-coiler	passively de-coiling
Load-bearing of de-coiler	5 T
Frame of machine	welded with 350H beam steel
Thickness of wallboard	18mm
Guide feeding way of forming	side direction roller type
Forming machine type	wallboard and chain drive
Diameter of shaft	￠70mm
Chain	16A single row
Motor power of forming machine	5.5KW
Line speed of forming machine	10-15m/min
Steps of forming machine	18
Roller material	superior 45# steel forging
Thickness of Chrome plated on roller	0.05mm
Hydraulic station motor	4 KW, pressure: 8-12Mpa
Hydraulic station oil pump	gear pump
Cutting blade material	16.Cr12
Cutting blade heat treatment	17. HRC58º-60
Rolling thickness	0.3-0.8 mm
Feeding width	1000mm
Precision of cut-to-length	20.±2mm
Electrical control system	Computer adopts PLC (Panasonic)
Voltage	380V, 50Hz, 3 Phases

Technological process:

Passively de-coiling → Guiding & Feeding material → Roll Forming → Cutting-to-length → Output panel

Equipment configuration

Normal manual De-coiler (5T); Main machine of roll forming; Hydraulic forming cutting; Hydraulic station; PLC computer operation cabinet; Run-out table